Problem with new version 1.0.4.3

#1

anycubic mono x says “failed to open file!” on all files sliced with version 1.0.4.3 files that were sliced on older version (I believe it was 1.0.3.2) still work fine so I know it is not my printer or usb drive

Photon Mono X - Failed to open file
#2

Hi Marcus,

We updated the file format from photonworkshop to the latest versions.
Are you able to update the firmware on the printer to 3.5.4 from the anycubic site? (this will fix the issue normally)

kind regards
Elco

#3

Hi Elco,

That did the trick. Thank you.

Marcus