Bugs & errors

About the Bugs & errors category (1)

Unwanted thin film appearing with V1176 (4)

Non persistant command (1)

Z minima dissapeared in v1174 (3)

Island detection flawed in v1165 (1)

Wrong volume calculation/output (1)

Adding new printer fails with error (2)

Text back the front (2)

NaN (Not a number) in all resin related fields (9)

Whats different about DEFT resin? (4)

Function "part replace" shifts the new part to the side (16)

File Mismatch from Halot Box to Halot One (2)

I cannot activate formware 3d with my license file (6)

Automated Supports not consistant (9)

Anomalies in Phrozen Transform G-Code Generation (10)

Missing Layers when bottom layers set to >9 (5)

Geometry badly altered when slicing (5)

Configure page missing lower part (4)

Creality Halot One Plus - This model does not match the printer (3)

Anycubic Photon Mono M5s two Stage lift bug (6)

Automatic Support geneartion bug (9)

NOVA3D WHALE3 PRO Slicer File generation WRONG (2)

HALOT ONE Timings are off since last update (4)

Parts appear mirrored again (10)

Can't find "Slice setup" on "Configuration" (4)

Auto-Generated supports go thru part and base intersect with part (2)

Elegoo Saturn - Ignoring Movement Settings (3)

Anycubic Photon Mono X firmware installed incorrectly (3)

Auto Orientation, approx amt of orientations displayed wrong (2)

Anycubic Mono X movement in 2 Stages (7)